1. If the Standard Cylinder has to be Removed
for Re-Keying see Below:
Lever
Handle
#1802
Cylinder
Retainer
Spring Pad
14-5407-9034
Cylinder Spacer
14-5407-9201
(Must be used with
6 Pin Cylinder Only)
Schlage®
Cylinder
Threaded
Collar
Schlage® Connecting
Bar 14-5496-0460-048
Schlage® Cylinder Cam
14-5407-1036-048
For Schlage® Removable
Core match driver position
in handle to the sketch
below for proper alignment.
Roll Pin
99-9999-3942-999
(.094 Dia. x .375)
1.
Remove threaded collar and Schlage® tailpiece.
2. Install Connecting Bar with threaded collar.
(Adjust collar for proper end play of plug.)
3. Slide Cylinder Cam onto Bar. (Note orientation of
notch.) Fasten with roll pin.
4. Slide shell sleeve onto cylinder.
Follow instructions on page 3 to install cylinder
into lever handle.
Shell Sleeve
14-5407-9101-999
Schlage® is a registered trademark of Schlage Lock Corporation
6
CAUTION
:
The cylinders furnished with the E5496LN lock for use in 1-3/4 - 2” doors have a tailpiece that is 1/4”
shorter than the standard cylinders that are furnished with 5400LN locks. Trying to install a standard
cylinder in 1-3/4 - 2” thick doors with a E5496LN lock will DAMAGE the lock body. Standard 6 & 7 pin
cylinders may only be used on 2-1/4” thick doors provided their overall length does not exceed 2-7/8”.
To Remove Cylinder from Handle
1. Remove retainer spring pad.
2. Slide cylinder out of handle.
To reassemble reverse
procedure. (Be sure spacer is
installed on back of cylinder
plug.) Water may br used to
lubricate spring pad to aid
installation.
11/32
(8.7)
For Yale
7 pin cylinder
cut to 11/32” as shown
®
Retainer
Spring Pad
90°
Correct position of
Schlage
®
Connecting
Bar when assembled
toward free end of
handle
Verify Cylinder Tailpiece
Length (See Below).
2-5/8” (66.5) For 6 & 7 pin cylinders 1-3/4 - 2” thick doors
2-7/8” (73) For 6 & 7 pin cylinders 2-1/4” thick doors ONLY
1-3/16” (30) For 6 pin cylinders 1-3/4 - 2” thick doors
1-7/16” (36.5) For 6 pin cylinders 2-1/4” thick doors ONLY
15/16” (24) For 7 pin cylinders 1-3/4 - 2” thick doors
1-3/16” (30) For 7 pin cylinders 2-1/4” thick doors ONLY
Yale Conversion Kit E107S
For Schlage® Cylinders
When used in 5496LN Locks
To Install Connecting Bar
II
-D Re-Keying
Competitor Cylinders
Standard
6 & 7 Pin
Cylinder
Data
