4
I
-B. Locate and Drill Holes for Electronic Components.
1. Mark door and position templates (Included).
a.
Draw a horizontal centerline for the lock on both sides of
the door at the desired height above the finished floor
line. Standard height for horizontal centerline is 40-5/16”
above finished floor (see Figure 1). (You may already
have done this in Step A1a Fig.1 pg. 3.)
b.
Line up installation template with 2-1/8” cross bore and
vertical backset centerline.
c.
Mark center point of additional holes to be drilled in door.
D.
Repeat step
1B
for inside of door.
2. Drill holes in both sides of door.
INSTALLATION
TEMPLATE
C
L
C
L
LOCK BODY
VERTICAL CENTERLINE
TAPE TO DOOR
SECTION
II
Prepare Lock for Installation
Left Hand
Reverse:
Hinges on
left, opens
outward. For
handed
locks, specify
LHR.
Left Hand:
Hinges on
left, opens
inward. For
handed locks,
specify LH.
Right Hand:
Hinges on
right, opens
inward. For
handed locks,
specify RH.
Right Hand
Reverse:
Hinges on
right, opens
outward. For
handed
locks, specify
RHR.
If the lock body is not correct hand, See Section
II
A Below.
What is the hand of the door?
Face the door from the outside to determine it’s hand. The outside is the keypad side of an entrance door or the
corridor side of a room door.
II
-A How to change hands (Standard Cylinder Locks)
Remove Handle & Escutcheon
Rotate Escutcheon 180°
Replace Handle
Opposite Hand shown in Up-right
Position.
Remove Cylinder Handle
1. Insert key and rotate clockwise 70°.
2. Depress retainer with tool provided.
3. Slide lever off lock. (Also applies to inside lever).
RH, RHR SHOWN
LH, LHR SHOWN
Fig. 3
