5
Removable Core - Change Hands
Remove Retaining
Ring & Handle
Rotate Handle & Retaining
Ring 180°
Replace Handle & Retaining Ring
in this Position.
Go to step
II
Cf.
A
B
C
E
F
Refer to steps below to
remove handle assembly
from Lock Body.
II
-B How to change hands (Interchangeable Core Cylinder & Non Cylinder Locks)
II
-C
To Adjust for Thicker Door
A.
Remove (2) screws from outside rose.
B.
Slide outside rose away from lock body.
C.
Pull pins out of lock body.
D.
Adjust rose plate to desired door thickness per
illustration below.
E.
Slide pins back into position.
F.
Fasten outside rose to lock body with (2) screws.
(Lock is packed preadjusted for 1-3/4” (44mm) doors.)
Adjust lock for door thickness
If necessary
2-1/4” door *
2” door
1-3/4” door
Slide plate
to disengage
D
1
LH, LHR SHOWN
RH, RHR
SHOWN
3
2
* 2-1/4 door thickness is a special order
or see Standard 6 &7 Pin Cylinder Data
Section (Page 6)
