User Manual for Knob Fingerprint Lock
: Function Description:
Ⅰ
Management: Two-level management, Master fingerprint has high authorization, can add or delete user fingerprints.
Lower Voltage Alarm: If the lock emits ¡Di---¡or five times, it means that the voltage is low, please change batteries.
: Electrical Parameters:
Ⅱ
Supply Voltage
：
6VDC (4 pcs of AA Batteries)
Standby Current
：
<7uA
Operating Current
：
200mA
Operating Temperature
：
-20
℃
~ +75
℃
Operating Humidity
：＜
85%
Master Fingerprints
：
2
User Fingerprints
：
125
: Operating instruction
Ⅳ
1) Enroll the first mater Fingerprint
1.1
Press the ADD button, you will hear a short beep. Then press the Don¡t disturb button, you will hear another short beep. the green and
red lights will flash, and the white light in the fingerprint reader area will flash.
Note:
If it emits long ¡Di---¡ (long), ¡Di--¡ (short), ¡Di---¡ (long), ¡Di--¡ (short), that means two Master Fingerprints have been set.
1.2
At this time, please put a finger that will be set to be master finger on the fingerprint sensor, don¡t move the finger until you hear any
sound
.
If this finger has been enrolled successfully, it will emit a long sound ¡Di-----¡ and the signal light will turn off. If unsuccessful, it will
emit two sounds ¡Di---Di---¡ and the signal light will turn off.
1.3
The fingerprint sensor turns off. This operation completes.
If this fingerprint has been enrolled to the lock, it will emit ¡Di---Di---Di¡ 3 sounds and exit the enrollment state.
Do the same to enroll the second master fingerprint.
2)
Change the master fingerprint to another one.
2.1
Put the master fingerprint on the sensor (the one not to be changed), and it emits a sound ¡Di---¡ and the green lights flash. Press and
hold the Don¡t disturb button for more than three seconds, it emits a long sound ¡Di-----¡ and the red and green lights flash alternately.
2.2
Put a finger on the fingerprint sensor, which will be the new master finger. Don¡t move the finger until you hear a sound ¡Di---¡
.
2.3
If the master finger changes successfully, it will emit a long sound ¡Di-----¡. The old master fingerprint has been replaced. If unsuccessful,
it will emit two sounds ¡Di---Di---¡.
Press the ADD button
Then press the Don¡t
disturb button, and put a
finger on the sensor.
Put a master
fingerprint
Press the Don¡t
disturb button, put
the new master
