Figure 1
Figure 3
Figure 2
DOOR PREPARATION
1. Fold and apply template to high edge of door at desired height
from floor.
2. Mark hole centers on door and door edge.
3. Drill 5/16" thru-bolt first, then drill 2 1/8" hole.
INSTALL LATCH
1. Drill 1" diameter hole for latch. Mortise for latch front.
(Insert latch and fasten with two screws).
Note: It is important that both 1" and 2 1/8" holes be on
same horizontal center line.
HOLLOW METAL DOORS
Must have horizontal and vertical lock and latch case
support provided by door manufacturer.
1. If 2 1/8" hole exists, use optional DORMA 76002026 Installation Tool
to insure accurate locating and drilling of 5/16" Thru-Bolt holes.
2. For best results, align and clamp the 76002026 tool to door
before drilling.
INSTALL STRIKE
1. Align strike with latch.
2. Trace strike outline on door jamb.
3. Mortise jamb and install strike and dust boot.
CL800 Series Cylindrical Lever Lock
Installation Instructions
PAGE 1
Figure 4
CL800 12/0276002009
LC Lever Design
LR Lever Design
DOOR PREPARATION
