Instruction #28-13-336 Rev.3 - Page 4 of 13
5
6
7
LIGHT BAR HARDWARE.
ATTACH BRACKET ASSEMBLIES TO LIGHT BAR.
CENTER LIGHT BAR AND ADJUST SLOT/SPRING NUTS.
M10/12
M6
M8
Determine whether your light
EDUXVHV000RU
0VFUHZV8VHRYHUODSSLQJ
holes as shown from left to
ULJKWIRU00DQG0
:DVKHUVDQGORFNZDVKHUV
are provided to prevent
damage to your brackets.
Attach the 2 bracket assemblies to
your light bar using the screws supplied
with your light bar. The appropriate
sized washers are supplied with the
/LJKWHQ8S/LJKW%UDFNHW
Finger tighten screws to allow the light
bar to be adjusted once mounted.
NOTE:
M8 light bar hardware is shown in this example.
NOTE:
(QVXUHWKDWSRVLWLRQRIOLJKWEDURUPXOWLSOHOLJKWEDUVFRPSOLHVZLWKUHOHYDQWVWDWHOHJLVODWLRQ
=
=
=
=
Position and center the light bar and bracket assembly on the Platform or crossbar by
ensuring there is an equal distance from the Platform corners or crossbar ends as shown.
Adjust slot/spring nuts in the channel so that they align with the openings in the bracket
bases. The Torx wrench can be used to assist nut movement within the channel.
2X
