Yaesu ZCUT-3EX, Instruction Manual

Page: 8 / 12

If the cutting length is short, cut tape may not reach to the outlet and may
not be fed with one cutting.
Press start button or start switch to load short length tape to make it come
out from outlet.
■
Make sure that blue LED LAMP is off.
・
When the POWER SWITCH turn on, setting mode will be previous used
setting.
■
Press the START BUTTON or START SWITCH, the machine will start
cutting and every piece ready to take it.
■
In the case of cutting any longer than 90mm, it is effective to lift a tape up
while taking a tape. Then next piece of tape will come out like automatically.
AUTO MODE (LED LAMP is on )
MANUAL MODE (LED LAMP is off )
Useful mode, when the set tape length is long enough to come out from
outlet by one cutting.
■ Make sure that blue LED LAMP is on.
・
If the blue LED LAMP is off, press the AUTO/MANUAL BUTTON to turn it on.
■ Manipulate the START BUTTON or START SWITCH to cut a tape.
・
Remove the piece of tape and machine will automatically cut another piece
each time when you remove the cut piece.
This machine can be set manual mode or auto mode.
Setting the Mode
■
Make sure that cutting length is displayed.
・ The cutting length will be displayed as A, b, C, d, E, F with 3 digits, or 4
digit number.
・
If cutting length is not displayed, press SELECT BUTTON more than few
seconds to display cutting length.
■
Set the cutting length.
・ Set the desired length by pressing the +/- BUTTON.
・
6 different cutting lengths (-999mm) or 1 cutting length (-7000mm) can be
memorized.
・ You can select memorized length A~F by using SELECT BUTTON.
・
The length is adjusted in 1mm increments, or press the button to fast forward.
■ The length will be memorized automatically after 3 seconds.
■
If you turn the POWER SWITCH off right after you set the length, length
will not be memorized.
Caution: The minimum cutting length is 30mm. However, the tape may be
jammed depending on the type of tape used. Please have a cutting
test before starting the operation.
Setting the Tape Length
INDICATE CUTTING LENGTH
A
～
F
SET THE CUTTING LENGTH
INCREASE NUMBER
DECREASE NUMBER
(exp. A-100mm)
4 digits
4 digits
CUT and STAND BY
CUT and STAND BY
REMOVE THE TAPE
REMOVE THE TAPE
TAPE FEED
TAPE FEED
LIGHT ON
SET AUTO / MANUAL
LIGHT OFF
LED LAMP
MANUAL MODE
MANUAL MODE
AUTO MODE
AUTO MODE
8