Yaesu ZCUT-3EX, Instruction Manual

Page: 10 / 12

Memo function
Present cutting quantity can be memorized.
■
Press AUTO/MANUAL BUTTON more than few seconds to display present
cutting quantity.
■
Press
＋
BUTTON.
・ Present cutting quantity will be forwarded and memorized.
・
Forwarded data will not be deleted even if power switch was turned off.
■
To display cutting length, press AUTO/MANUAL BUTTON more than few
seconds.
Count up function
■
Press AUTO/MANUAL BUTTON more than few seconds and display
present cutting quantity.
■
Press
−
BUTTON, then present cutting quantity will be reset, and display
will indicate 0.
■
Machine will start operation with the previous used mode.
■
To display cutting length, press AUTO/MANUAL BUTTON more than few
seconds.
■
Cutting quantity will be counted continuously even the setting mode is
changed.
( After the cutting quantity of 9999, the number will be reverted to 0. )
Maintenance
■
Use wrung cloth which was dipped in water with natural
detergent.
■
Keep clean for where tape passes through.
・ Inspect and clean around all ROLLERS and BLADE,
and make sure that there is no foreign material around.
■
Procedure of replacing blade cutter
①
→
②
→
③
①
Remove the SCREW by using the accessary of
HEXAGONAL SPANNER.
②
Grip the PROTRUSION on BLADE HOLDER,
pull it up and slide it as the drawing to take
out the BLADE.
③
Slide off to the left side and pull the BLADE.
■
Please replace the BLADE in an opposite
procedure.
10
BLADE
ROLLERS
SCREW
BLADE HOLDER
PROTRUSION
HEXAGONAL SPANNER
HOW TO REPLACE THE BLADE
DISPLAY PRESENT CUTTING QUANTITY
DISPLAY PRESENT CUTTING QUANTITY
( PRESS MORE THAN FEW SECONDS )
( PRESS MORE THAN FEW SECONDS )
①
②
③
CAUTION:
CUTTING EDGE
IT MIGHT CAUSE AN INJURY.
WHENEVER YOU CLEAN OR REPLACE
THE BLADE, DO NOT TOUCH THE
SHARP EDGE OF THE BLADE.