Yaesu ZCUT-3EX, Instruction Manual

Page: 7 / 12

7
Load i n g t h e Tap e
■ The SOCKET-OUTLET shall be installed near the eq uipment and shall be
easily accessible.
■ Set the machine only in the upright position.
■
Plug in AC CORD to the AC CORD INLET.
■ Make sure the POWER SWITCH is off then plug into an appropriate
SOCKET-OUTLET.
■
Turn the POWER SWITCH on.
・ When the POWER SWITCH is turned on, a letter, A, b, C, d, E, F and 3 or
4 digits will be displayed on CONTROL PANEL.
( Previous use cutting length will be displayed)
・
When the POWER SWITCH is turned on, mode setting is set to previous use.
■ Put a tape into BOBBIN and set them back to the machine.
■
Lift the SAFETY COVER HOOK and open the SAFETY COVER.
■ Fold the edge of tape about 20-30mm to the sticky side, and insert the
tape between TAPE FEED ROLLER and SILICON SPONG E ROLLER.
■
Press the FWD BUTTON to feed out the tape.
・ Press the FWD BUTTON until the tape comes out from the tape outlet.
・
If the tape comes out inclining, press the FWD BUTTON until tape comes
out straight.
・
FWD BUTTON operates only while pressing the button.
■ Close the SAFETY COVER and replace a hook.
■
Press the START BUTTON, or lift the START SWITCH up and down.
・
Pressing the START BUTTON or the START SWITCH after pressing FWD
BUTTON, the cutting blade starts operation to cut the tape.
・
Remove first piece of tape and discard it.
■ When you pull out tape from TAPE FEED ROLLER, please follow the
instruction below.
・ Lift the SAFETY COVER HOOK and open the SAFETY COVER.
・
Press REV BUTTON, and reverse the tape.
・
After front edge of the tape comes out between TAPE FEED ROLLER and
SILICON SPONG E ROLLER, stop pressing REV BUTTON.
Caution: If you keep pressing REV BUTTON even after all tape was
reversed, tape might get caught in TAPE FEED ROLLER
from opposite.
LOAD THE TAPE CONFIRM THE SETTING
START SWITCH
CUT THE TAPE
REMOVE THE TAPE
Op en t h e
saf et y c ov er
SOCKET-OUTLET
BOBBIN
SET UP THE TAPE
AC CORD
INLET
AC CORD