Yaesu ZCUT-3EX, Instruction Manual

Page: 11 / 12

START
START
11
Error Messages
The buzzer will sound and the message will flash on the display.
E-02 BLADE IS OUT OF POSITION
E-03 MOTOR IS STOPPED
A signal shows that the blade is not installed correctly or the tape is jammed.
・
Turn the POWER SWITCH off.
・ Open the FRONT PANEL and inspect around BLADE and all rollers.
・
If you see some tape is jammed, remove the tape carefully.
・ Close the FRONT PANEL and tighten the SCREWS.
・
Close the SAFETY COVER and replace the HOOK.
・ Turn the POWER SWITCH on.
・
Press START BUTTON. Display will indicate E-02 with the buzzer sound.
・ Press START BUTTON again, then blade will be positioned in readiness.
・
Follow instruction and set up again.
This indicates that the motor is stopped because of an overloaded.
・ Turn the POWER SWITCH off.
・
Open the FRONT PANEL and SAFETY COVER.
・ Inspect around all rollers and make sure that foreign materials are not stuck
around rollers.
・ Clear any tape residue or tape pieces carefully.
・
Close the FRONT PANEL and tighten the SCREWS.
・ Close the SAFETY COVER and replace the HOOK.
・
Turn the POWER SWITCH on.
・ Press START BUTTON and check whether machine is operating normally.
・
Follow instruction and set up again.
Blade positions in
readiness
Load the tape
Load the tape
POWER SWITCH is off
Open the FRONT PANEL and
SAFETY COVER
Inspect around BLADE and
ROLLERS
Remove foreign material
Close the FRONT PANEL and
SAFETY COVER
POWER SWITCH is on
POWER SWITCH is off
Open the FRONT PANEL and
SAFETY COVER
Inspect around BLADE and
ROLLERS
Remove foreign material
Close the FRONT PANEL and
SAFETY COVER
POWER SWITCH is on
DO NOT TOUCH THE BLADE WHEN YOU ARE CORRECTING AN ERROR
UNDER POWER SWITCH IS ON.
TURN OFF THE POWER SWITCH AND STOP USING THE MACHINE. IF THE
MACHINE CANNOT WORK NORMALLY AFTER CORRECTING THE ERROR.
IT SEEMS THAT NOTHING WRONG WITHOUT ANY ERROR MESSAGES.