78
z
Setting the scan resume time
You may select a waiting time till the resuming of scan
after the encountered signal disappears (see page 55).
z
Setting the operation after stopping a scan
You may select either of the operations below when en-
countering a signal during a scan (see page 55).
Busy Stop
... Stays at the frequency and will not
resume the scan
5sec Stop
... Stays at the frequency for 5 seconds
and then resume the scan
10sec Stop
... Stays at the frequency for 10 seconds
and then resume the scan
z
Setting the polled frequency for dual watch
See page 46 for details.
z
Setting the transmit frequency during the
NAV band reception
See page 43 for details.
z
Setting the frequency step for tuning
See page 49 for details.
z
Setting the time-out timer for transmission
See page 47 for details.
z
Setting the microphone configuration
See page 48 for details.
z
Setting the side tone operation
See page 48 for details.
z
Setting the audio filter of the receiver
You may select the operation of the audio filter from
the following 4 types.
Normal
... No filtering
Low Cut
... Cuts off the lower range of sound
High Cut
... Cuts off the higher range of sound
High And Low Cut
... Cuts off the higher and lower
ranges of sound
