Yaesu FT5Dr, Advance Manual

Page: 23 / 73

23
• If the scanner halts on an incoming signal, the back light will turn ON and the
decimal point between the “MHz” and “kHz” digits of the frequency display will blink.
• Scanning will resume in about five seconds.
3. Touch [ STOP ] or press the PTT switch to cancel the scanning.
In this state (displayed as “ PMSP
££
” at the upper left of the display), the frequency
can be changed by turning the DIAL knob only in the upper/lower limit frequency
range stored by PMS memory.
z
Disable the PMS function
1. Press the [
V/M •
] key.
Return to the normal memory mode.
Memory Bank Scanning
Scan only the memory channels stored in the recalled memory bank.
1. Recall the memory bank you want to scan by referring to “
Open the Memory Bank
display ” (page 18) and “ Open Memory Bank Channels ” (page 18).
2. Press [ F
MENU
]

[ SCAN ].
If [ SCAN ] is not displayed, touch [ BACK ← ] to display [ SCAN ] and then touch it.
Memory bank scan starts.
Memory Bank Link Scanning
During regular memory bank scanning, only the memory channels assigned to the
recalled memory bank are scanned. During memory bank link scanning, you can scan
memory channels registered in two or more banks you specified in advance.
Setting Bank Link
1. Press and hold the [ F
MENU
] key

touch [ MEMORY ]

[ 1 BANK LINK ].
2. Rotate the DIAL knob to select the memory bank for which you want to perform bank
link scanning.
3. Press the [ F
MENU
] key, a check mark will appear and it will be set to Bank Link.
4. Repeat steps 3 and 4 to select other memory banks.
5. Press the PTT switch to save the setting and return to normal operation.
Performing Bank Link Scan
1. Recall the memory bank set as bank link by referring to “ Open the Memory Bank
display ” (page 18) and “ Open Memory Bank Channels ” (page 18).
The memory bank number is changed from [B] to [b] and the bank link scanning is
activated.
2. Press the [ F
MENU
] key

[ SCAN ].
If [ SCAN ] is not displayed, touch [ BACK ← ] to display [ SCAN ] and then touch it.
Bank Link Scanning is performed toward the higher memory channel numbers.
Press and hold the [
DISP
] key

touch [
SCAN
]

[
5 SCAN WIDTH
]

[
BANK LINK
] is set
to “ OFF ”, to temporarily disable banklink and perform normal memory-bank scanning while
banklink is set.