2) As soon as you believe having found the best mounting
location of the transducer, release the pivot from the
template, then mark the third hold with a pencil.
3) Using a 5/32” bit, drill a hole appreciated 1” (25mm)
deep at the marked position.
4) Apply some marine sealant in three holes and hold the
template against the transom. After you are certain the
installation is completely in line with the mounting
location which you got at step 4, then tighten the three
screws with Allen wrench
DŽ
5) Press the pivot into the template.
The third hole
Summary of Contents for NAKI8850B
Page 2: ......
Page 6: ...Specfications and Feature 49 Specfications 49 Features 50 Contact us 51 iv...
Page 58: ......
Page 59: ...www goyachting cn...