Yachting Electronic Co. NAKI8850B, User Manual

Page: 17 / 59

2) Adjust the template to make it roughly vertical to the
water surface
ˈ
then tighten the two screws with Allen
wrench
3) Press the pivot into the bracket, and then rotate the
transducer to make it parallel with the water surface.
Note: The pivot match the transducer by ratchets
ˈ
and
the increment is12 degree, so in some situations you
may find it impossible to adjust the transducer completely
parallel with the water surface. In this situation a slight
incline (1~5degree) is acceptable.
5. Rout 5. Routing the ca ing the cable ble
According to the different situation of boat, you could
choose to route the transducer through or over the transom
to the sonar unit.
If you choose to route the transducer through the transom
to the sonar unit, please follow the steps bellow:
1) hold one cable clamp at the position approximate 1/4
distance from the top of transom to the transducer
ˈ
then
mark the position with a pencil. Using a 1/8” bit, drill