![background image](http://html1.mh-extra.com/html/yachting-electronic-co/naki8850b/naki8850b_user-manual_3083767014.webp)
holes should be parallel
with water surface.
Make sure the distance between
the bottom of template and the
lower edge of the transom
is about 0~5mm.
3) Using a 5/32” bit, drill 2 holes approximate 1” (25mm)
deep at the marked location. Be careful not drilling too
deep then 1”.
3. As
3. Assemble
semble the transducer
the transducer
1) Slightly spread the pivot
and match the transducer
to the pivot. The toothed
surface make them not
separating easily.
Note:
Note: when match the
transducer and pivot, please be
a)
b)
Mark the two position
0~5mm
Summary of Contents for NAKI8850B
Page 2: ......
Page 6: ...Specfications and Feature 49 Specfications 49 Features 50 Contact us 51 iv...
Page 58: ......
Page 59: ...www goyachting cn...