-22-
Safety Notice
This NFC module is mounted below the resin bottle slot. The FCC ID of NFC module is 2AB9W-CT-NFC.
Caution!
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
●
Error Code 2004: Lid not covered during printing
Suggestion:
Place the lid on the printer before printing. If the lid is placed correctly, please remove the lid, select "INFO">"SENSOR STATUS", tap the lid sensor and see if the status of
"C" switches from 0 to 1. If the value doesn't switch accordingly, then the sensor is malfunctioning. Contact the service center after you have checked the status of the
printer.
●
Error Code 2005: Unrecognized resin tag
Suggestion:
Check the record of the resin bottle by selecting "INFO">"RESIN STATUS". If the display shows "UNIDENTIFIED TAG", please change to XYZprinting resin bottle.
●
Error Code 2006: Unable to resolve the file
Suggestion:
Slice the file again with XYZware_Nobel. Be sure to set “Printer Type”as Nobel Superfine while slicing the file.
●
Error Code 2007: File too large
Suggestion:
Please select a .3wn file, size no more than 200MB.
●
Error Code 2008: Non-manifold issue is found in the file
Suggestion:
Repair the file with 3D model repairing software (such as netfabb or MakePrintable) and slice the model with XYZware_Nobel again.
●
Error Code 2009: Resin tank is not installed correctly
Suggestion:
Confirm if the resin tank is installed correctly. If the resin tank is placed correctly, remove the tank, select "INFO">"SENSOR STATUS" on the printer, touch the resin tank
sensor, and see if the status of "T" switches from 0 to 1. If the value doesn't switch accordingly, then the sensor is malfunctioning. Contact the service center after you
have checked the status of the printer.
●
Error Code 2020: Printer is busy
Suggestion:
Wait until the printer finishes current task. If the error persists when the printer is idle, please try to restart the printer.
