P6
da Vinci Color mini
Unpacking and Installation
Installing the Extruder module and the guide tube
1. Make sure that the printer is powered
off. Place the extruder module that the
fitting pin is secured the proper location.
2. Connect the bus (make sure it clicks into place).
Mask Tape
PC Mylar
EZ Removable
Rubber Magnet
6. Please follow the order as image instruction, attach the PC
mylar and mask tape on the EZ removable rubber magnet.
7. Confirm the rubber magnet is well placed on the print bed.
4. Pass the guide tube going through
the top. Then insert the other end
into the clear tube (Accessory 13).
3. Insert one end into the feed module, ensure that the guide tube
has been tightly inserted into the port.
There is a sheet of PC film to
rubber magnet with a double
sided adhesive, this PC film is
replaceable, please replace it
when it's dirty or broken.
Note
5. Insert the other end of the guide tube into the feed moduleand
secure it tightly.
