Xylem wtw MIQ/R6, Operating Manual

Page: 14 / 24

Installation MIQ/R6
14
ba75541d07 03/2018
Connecting lines
to the terminal
strip
Fig. 3-1 Terminal strip with the relay connections
1 Open the module.
2 Screw the cable gland (pos. 1 in Fig. 3-1) with the sealing ring (pos. 2)
into the module housing.
3 Loosen the coupling ring (pos. 3 in Fig. 3-1).
4 Feed the line through the cable gland in the module housing.
5 Connect the wires to the terminal strip. While doing so, pay attention to
the specifications on the label located under the terminal strip.
6 Tighten the coupling ring (pos. 3 in Fig. 3-1).
WARNING
No free wires are allowed to project into the housing. Oth-
erwise, there is a danger that areas safe to contact could
come into contact with dangerous voltages. Always cut
off any wires that are not in use as closely as possible to
the cable gland.
1
3
2
X6 X5 X4
SENSORNET 2
RED RO
T
SHIELD SCHIRM GREEN GRÜN
X3 X2 X1
SENSORNET 1
RED RO
T
SHIELD SCHIRM GREEN GRÜN
ON
EIN
OFF
AUS
SN
TERMINA
TO
R
2 2
Relay output
X18 X17
240 VAC
2 A AC
R6
X16 X15
240 VAC
2 A AC
R5
X14 X13
240 VAC
2 A AC
R4
X12 X10 X8 X11 X9 X7
240 VAC
2 A AC
R3
240 VAC
2 A AC
R2
240 VAC
2 A AC
R1
Segment 2 Segment 1
All manuals and user guides at all-guides.com