Page 34
June 2022 – TD 320 OPERATING MANUAL – TURBIDITY SENSOR 4296
When the connection is
established, a small window will
show up with a green check mark
confirming this.
The status changes to green when
the port is open.
Then click on the
Control Panel
button on the lower right corner to
continue.
If the wheel continues turning and you do not get the green status, please press
Close Port
and
then
Open Port
again. If you still face a connection problem, then check the port setting with
Baud Rate
and
Port Name
. If you still cannot connect, check the cable connection and make sure
that you have power to the sensor. If the sensor is running on a fast interval this connection can
be a bit slower.
3.2
Control Panel
In the
Control Panel
window, you will find two tabs,
Recorder Panel
and
Device Configuration
.
Under
Recorder Panel
you can start and stop recordings. If the recorder is running first click on
the
Stop Recorder
as you are not allowed to configure the sensor when recording. The
Recorder
Panel
is dependent on the Sensor Mode. In
AADI Real-Time
mode you may start and stop the
recorder. For
AiCaP
and
Smart Sensor Terminal
you can only refresh the status but not start the
recording.
Figure 3-4: Connection established
Figure 3-5: Green Status