KPM(T) Series Flat Panel Industrial Monitor
Chapter 1 – Introduction
7 143448 (
D
)
The Touch Out RS-232 is used when the touch screen option is utilized. A cable in
this port sends the signals from the touch screen to the computer.
There is a USB port on the front of the monitor that can be used at any time. This is a
pass-through only; there is no local USB activity on your KPM(T) monitor. To make
your device work, you must have a cable going out to the computer from the USB
port on the back of the monitor.
Caution
The USB cable that is used to connect the USB device cannot be more than 5 meters in
length from the host computer, or the device will not work correctly.
Pro-face
ships a
3M USB cable with the 5012KPM(T) monitors and 5015KPM(T) monitors.
As a basic part of the initial setup of your KPM(T) monitor, you will connect a cable
to both the AC port and the Video In port. The cable from the computer to the Video
In port provides the signal connection for the monitor. An RS-232 cable sends touch
screen signals to the computer. A PS/2 cable connected to the ‘host keyboard’ port
sends keypad (or an optional external keyboard) signals to the computer. A PS/2
cable connected to the ‘host mouse’ port sends integral mouse (or an optional
external mouse) signals to the computer.
Unpacking the Unit
When you remove the KPM(T) monitor from its shipping box, verify that you have
the parts listed below. Save the box and inner wrapping in case you need to reship the
unit.
••••
5012KPM(T) or 5015KPM(T) monitor
••••
Documentation kit, which includes
•
10-32 hex nuts (12)
•
Analog RGB Cable (10 ft.)
•
RS-232C Cable (10 ft.)
•
Two PS/2 cables (10 ft.)
•
USB Cable (3 m)
•
Documentation and Support Library CD-ROM, which contains this manual
and all drivers required by this unit
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com