4
Version 1 – GBR (05/05/2020)
D-502-0173
1.
General information
1.1.
Introduction
-
This document "Installation and Instructions for Use" (IFU) is intended for MiracleAir 300-A extraction
unit and MiracleAir 400-B filter unit (hereinafter referred to as the unit) intended to extract and filter
indoor air in required spaces. The extraction and filtration unit is used to remove particles directly at the
place of their origin to protect the health of workers.
-
Detailed knowledge of this document is important for correct and safe installation and operation of the
unit. Failure to follow the terms in this document may result in malfunction of the unit.
-
Keep the IFU of the unit for future reference after thoroughly reading it.
-
It is forbidden to interfere with the internal wiring of the unit in any other way than specified in this
manual. Due to the constant development of our products, we reserve the right to change this manual
without prior notice.
1.2.
Warnings and symbols
-
The following names and symbols are used in the IFU, on the packaging and on the product for particularly
important information:
Warning
Caution, risk of electric shock
Connection of protective conductor
Indicates the correct position when handling and storing the packaging
Cautions about the need for protection against moisture. Product - packaging labelled with this symbol
may not be transported in open vehicles and stored in uncovered buildings and on the ground without a
pad
Draws attention to the fragility of the product contents and need for careful handling of the packaged
product.
Draws attention to the need for protection against moisture and the fragility of the product inside the
packaging
Orientation arrow for filter placement
1.3.
Using the unit
1.3.1.
Intended use of the unit
-
MiracleAir unit is intended for indoor use only, without dust over-saturation in the surrounding air to:
o
extraction of aerosol-smoke, which may be generated during medical procedures in association
with the treatment of the patient, e.g.: dental treatment, anaesthesiology management, etc.
o
indoor air filtration e.g.: medical facilities, waiting rooms, cosmetic facilities, offices, etc.
-
The unit is designed for the extraction and filtration of particles larger than 0.1 to 0.3 µm (filtration
efficiency of 99.95%).
-
The unit is designed for indoor use in covered and dry areas with an ambient temperature from 5° C to
+40° C and with a maximum relative humidity of 70% (non-condensing).