24
Version 1 – GBR (05/05/2020)
D-502-0173
o)
Put the sheet metal sides on the sides of the unit.
p)
Put the unit into operation according to point 6.2. Switching on
7.1.3.
Replacement of protective sleeve (only for the version with suction arm)
-
Replace the protective sleeve as required according to the procedure described in chapter 3.2.2.
7.2.
Cleaning the unit
7.2.1.
General information
-
When cleaning the unit, it is necessary to use appropriate protective equipment (e.g. gloves) to prevent
contact with any harmful substances.
-
Do not use compressed air, solvents or sharp objects to clean the unit.
-
Use a damp cloth with a general cleaning agent (soapy water) to clean the unit and the suction arm from
coarser dirt (dust).
-
Use standard non-aggressive disinfection to disinfect the unit and arm surfaces.
7.2.2.
Cleanable surfaces
-
The unit and the suction arm may be cleaned over their entire outer surface.
-
The extraction outlet may be cleaned both from the inside and from the outside.
-
The unit may be cleaned from the inside only at the extraction box. When cleaning, take care not to
damage the components protruding into the inner space of the extraction box (pressure measurement
point).
o
The procedure for removing the extraction box from the unit is described in the points 7.1.2.a)
to f).
o
The procedure for installing the extraction box back on the unit is described in the points 7.1.2.l)
to p)
8.
Service
-
warranty and non-warranty repairs are provided by the manufacturer at the registered office of the
manufacturer or according to the agreement.
-
The manufacturer reserves the right to make changes to the device, which will not affect the essential
performance of the device.
Fig. 28