XtremeAIR XA41, Maintenance Manual

Page: 52 / 284

Maintenance Manual XA41/XA42
AMM-XA42-0040-001 C.00
Page 2 Page date:
Chapter 07 25.09.2018
CAUTION
CAUTION
07-00-00 GENERAL
The XA41 and the XA42 have no special hoist points. Refer to chapter 07-10-00.
07-10-00 JACKING
To lift the aircraft, remove the top cowling. Attach the straps to the left and right side of the
engine mount as near as possible to the fuselage. The figure in chapter 07-20-01 shows the
straps that are attached to the engine mount.
To lift the rear of the aircraft: Push the aircraft up from below the horizontal stabilizer.
Only use straps with a permitted load of more than 1000 (kg)/2200 lbs.
Hold the wings with trestles to prevent the aircraft to tilt to one side.
07-20-00 SHORING
It is necessary to shore the aircraft during the installation or removal of the main or tail
landing gear.
07-20-01 Shoring the front
To lift the front, a support is necessary. The support area must be a minimum of 100 x 500
mm.
Put a cushion on top of the support to prevent damage to the fuselage.
To lift the front:
1
Lift the aircraft, refer to chapter 07-10-00.
2 Remove the spar bridge cover.
3 Put the aircraft on the support, refer to the figure below. Put the support below the
lower longeron connector brackets of the fuselage.
Do not remove the straps to make sure that the aircraft is safe while shoring.
Figure 07-1: Shoring the front
CAUTION