XtremeAIR XA41, Maintenance Manual, Page: 102 / 284

Maintenance Manual XA41/XA42
AMM-XA42-0040-001 C.00
Page 6 Page date:
Chapter 25 25.09.2018
3 DIN 12 socket for the connection of the remote control, a programming
dongle or a programming equipment
4 BNC connector for the antenna.
For a functional description and operating modes, refer to the manufacturer’s Installation
Manual/ Operation Manual.
You can program the ELT with:
• The aircraft registration
• A 24-bit address (same as MODE “S”)
• A / The serial number
• An aircraft operator designator.
Maintenance of the ELT is only necessary one time in a month. This is a self-test that is
started with the remote control in the cockpit or at the ELT, refer to MM ELT. The ELT status
is shown with a flashing indicator and a buzzer. For the maintenance procedures, refer to
the manufacturer’s Installation Manual/ Operation Manual.
Find the expiration date of the batteries and make sure that it is not expired. It is mandatory
to replace the battery:
• After more than 1 hour of transmitter operation (cumulative operating
time)
• Before the battery expiration date
• When the battery was used in an emergency
• After an accidental start of an unknown period of time
• After the recommended replacement time (refer to chapter 05-10-03).
Power for the transmitter is supplied with this battery:
• KIT BAT200, P/N: S1840510-01 (LiMnO
2
two-element battery)
Only an approved Part 145 (or equivalent) maintenance organization is permitted to replace
the battery.
25-60-02 Parachutes
For the maintenance of the parachutes, refer to applicable Instructions for Continued
Airworthiness (ICA) of the parachutes.
NOTE