XtremeAIR XA41, Maintenance Manual, Page: 153 / 284

Maintenance Manual XA41/XA42
AMM-XA42-0040-001 C.00
Page date: Page 7
25.09.2018 Chapter 32
To remove the tail wheel assembly:
1 Remove the split pin. Remove the nut on top of the tail wheel assembly. Refer to
Figure 32-3, detail Y.
2 Remove the tail wheel assembly.
3 Assemble the tail wheel assembly in the opposite sequence with a new split pin.
4 Add grease into the lubricating nipple.
5 Make sure that the tail wheel fork moves freely without too much play when the tail
wheel lock is disengaged.
To remove the control assembly of the tail wheel lock: Refer to Figure 32-6.
1 Remove the rear seat
2
Remove the TWL spring (Pos. 8), the TWL spring retainer (Pos. 9) and the Bowden
cable. Refer to detail L and H.
3 Remove the TWL slider bushing (Pos. 7) and the TWL slotted link (Pos. 6).
4 Remove two TWL idler bushings (Pos. 5) from the elevator bell crank. Refer to
chapter 27-30-02.
5 Remove the TWL cable bracket (Pos. 1).
6 Assemble the
control assembly
of the
tail wheel lock
in the opposite sequence.
7 Adjust the tail wheel lock.
8 Re-install the rear seat.
Figure 32-5: Control assembly of the tail wheel lock (between the rear seat frames).