6
FS5.4e Elliptical
1. Connect the Front Stabilizer (17) to the main frame with two Carriage
Bolts (105), two Curved Washers (148), and two Cap Nuts (106).
Tighten with the Wrench (156).
2. Connect the Rear Stabilizer (15) to the main frame with two Hex Head
Bolts (104), two Split Washers (146) and two Curved Washers (148).
Tighten with the Wrench (155).
3. Slide the Console Mast Cover (76) onto the bottom of the Console Mast
(10). Take the wire tie that exits the bottom of the Console Mast and
wrap it around the end of the Computer Cable (41) that is rolled up in the
frame bracket. Slowly pull the wire tie up through the top of the Mast (10)
and insert the bottom of the Mast (10) into the frame bracket. Secure the
Mast (10) with four Hex Head Bolts (102) and four Flat Washers (143)
to the sides of the Mast, and two Hex Head Bolts (102) and two Curved
Washers (147) to the front of the Mast. Tighten all bolts with the
Wrench (155).
4. Set the Console Mast Cover (76) into place over the Frame Covers.
5. Plug the Computer Cable (41) and theHand Pulse Sensor Wires (44)
into the back side of Computer Console. Attach the Computer Console
to the Mast with four Screws (115). Tighten with the Screwdriver (158).
FS5.4e
Assembly Instructions
Hardware Step 1
Rear Rail, Console Mast & Console
#102
. 5/16” x 15
Hex Head Bolt (6 pcs)
#104
. 3/8” x 3/4”
Hex Head Bolt (2 pcs)
#105
. 3/8” x 3”
Carriage Bolt (2 pc)
#106
. 3/8”
Cap Nut (2 pcs)
#115
. M5 x 10mm
Phillips Head Screw
(4 pcs)
#143
. 5/16” x 20 x 1.5T
Flat Washer (4 pcs)
#146
. 3/8” x 2T
Split Washer (2 pc)
#147
. 5/16” x 23 x 2T
Curved Washer (2 pcs)
#148
. 3/8” x 23 x 1.5
Curved Washer (4 pcs)
1