Studer Innotec SA
Xtender
User manual
V4.6.0
35
9
ACCESSORIES
9.1
R
EMOTE CONTROL
RCC-02/-03
An RCC-02/-03 remote control, display and programming unit can be connected to the Xtender via
one of the two RJ45-8-type "Com. Bus" (3) connectors.
Only Studer CAN compatible accessories and devices (mentioned in chapters 9 and 10)
can be connected to the RJ45-8 connectors, excluding any other connections such as LAN,
Ethernet, ISDN or other.
Connecting a non-compatible device may cause serious damage not covered by the
manufacturer's warranty.
These connectors may only be used for connecting a CAN-ST compatible accessory, excluding any
other connection such as LAN, Ethernet, ISDN, etc.
The RCC-02/-03 control centre is vital for modifying the parameters of the system. Many parameters
and features are not described in this manual. The manual for the RCC-01/03 (downloadable on
www.studer-innotec.com) describes in detail each of these parameters and the context in which
they can be used.
It also allows the following functions:
Display of function synopsis
Display of the measured operational values (current / voltage / power output, etc.)
Updating of software or implementation of customised software
Upload/download of inverter parameter
Updating of inverter parameters
Events logging of error message
Data acquisition of Xtender and other participants connected to the communication bus
like the BSP (Battery status processor) or / and compatible solar charge controller
RCC-02
RCC-03
The features of the RCC-02 and the RCC-03 are the same. They only differ in their external
appearance. The RCC-02 is designed for wall mounting, whereas the RCC-03 is designed as a board
device.
The RCC-03 model must be removed from the board to allow access to the SD card slot (during
updating, for example).
Model N°: RCC-02: Dimensions: H x W x D / / 170 x 168 x 43.5mm
RCC-03: Dimensions: H x W x D / / 130 x 120 x 42.2mm
The two remote control models are delivered with a 2 m cable.
Cables of specific lengths (5 m, 20 m and 50 m) can be ordered.
The article no. is as follows: CAB-RJ45-xx. The length in metres is specified as xx.
