12
www.XSscuba.com
XS Scuba Inspire Regulator Service Manual
v. Remove the filter (4) and o-ring (5) from the top
of the DIN housing (7). If necessary, you can push
them out from below using the TL136 Multi-pur-
pose tool.
vi. Remove the o-ring (8) from the bottom of the
DIN housing (7).
7. Remove the turret bolt assembly (28).
A. Turn the regulator in the vise so that the turret
(21) and turret bolt (28) are facing up.
B. Using a 6 mm hex key, remove the turret bolt as-
sembly (28).
8. Remove the turret (21).
A. Remove the thrust washer (26).
B. Remove the turret (21) by pulling straight up on it.
C. Remove the underlying o-ring (20).
9. Separate turret bolt assembly (28).
A. Separate the HP seat (22), and valve spring (23)
from turret bolt (28).
B. Remove the two outer o-rings (25,27) from the
turret bolt (28).
C. Using an o-ring pick, remove the internal o-ring
(24) from inside the turret bolt (28).
