Xray Nitro Micro NT18MT, Instruction Manual

Page: 7 / 28

7
IMPORTANT WARNINGS
A new, unused battery pack is guaranteed against manufacturer‘s defects and workmanship. Any damage due to misuse by the user will be repaired at the user‘s expense.
There is no warranty expressed or implied that covers damage caused by normal use, or covers or implies how long the battery pack will run (run time), or last before requiring
replacement due to normal use and normal cell degradation. XRAY shall not be liable for any damage caused by overcharging, battery failure, improper charging or discharging,
use of non-approved chargers, use of non-approved batteries, and alternations or modifi cations of any kind to the charger, batteries, switches, or wiring.
WARRANTY
INSTALLING THE ANTENNA
You must install the antenna tube before operating your micro nitro truck.
• Never disassemble the battery pack or peel away the cover.
• Keep the battery pack away from water.
• Do not touch the battery pack with wet hands or wet objects.
• Do not subject the battery pack to strong impacts and short circuits.
• Keep the battery pack away from fi re and fl ammable objects.
• Disconnect the battery pack when it is not in use.
• Do not put metal objects in the battery pack connector or touch the terminals
• in the connector.
• Do not throw away the battery pack when you no longer need it. Bring it to the shop from which you bought it, or to a shop offering battery recycling service.
• If leaked battery alkaline electrolyte gets in your eyes or on your skin, fl ush thoroughly with clean water and consult with a doctor immediately.
• Regularly check the wiring for damage. While running the truck, vibration or movement may cause damage to the wires which if left unchecked may result in a short circuit. If
any wire insulations becomes damaged, please dispose of the battery pack properly and do not use it, nor try to repair it.
• You are responsible for the proper use of this battery pack and any damage that may occur due to its use or misuse. XRAY is not liable for any injury, damage, or harm caused
to any person or property arising from the use or misuse of their products.
1. Locate the black antenna wire that exits the receiver. The receiver
is mounted on the top of the servo.
2. Pull the wire straight with your fi ngers and then insert the end of
the wire into one end of the antenna tube. Push the wire all the
way through the antenna tube.
3. Pull the remaining wire through the antenna tube, and then
insert the base of the antenna tube into the molded post on the
chassis to which the servo is mounted.
4. Fold the remaining antenna wire over the top of the tube. The
remaining wire can stick up.
TIP:
Spray a small amount of window cleaner on the antenna wire to
make it easier to push through the antenna tube.
Do not push the transmitter antenna down from the top. Pull it down
from the bottom, one segment at a time, to prevent binding and
kinking the antenna mast.
CAUTION !!!
Do not shorten the length of the antenna wire. Its length is tuned to the frequency band; cutting it may severely shorten the radio system’s range.
DECORATING THE BODY
The micro nitro truck body was hand-painted with premium-quality, high-gloss paint and several stickers were applied to the body.
If you want to use the included rear wing, you must trim it fi rst. When installing the wing on the Monster Truck make two holes in the rear of the body as indicated. Attach the rear
wing to the body using the included screws and plastic nuts. To install the wing to the truck use a double-sided tape.
Extra decals are provided to decorate and personalize your micro nitro truck body.
Use the tip of a hobby knife to lift the corner of a decal, then remove it from the backing sheet.
Position the decal over the desired location on the body, and press it onto the body. Pull tight on the decal if required, and use your fi ngers to smooth out any air bubbles.
Decals for NT18T Decals for NT18MT