21
SIP Operation Manual
Instructions
FXS Port: Connect FXS port to a telephone. To access IVR mode, you should enter factory
default code “
** #
” . If it requires password, enter ** password #”. Character to number
conversion information is provide in the
PPPoE Character Conversion Table
. After
entering the correct IVR password, you will hear an indication tone after which the gateway
is in IVR setup mode. Enter function codes to check or set the gateway configuration.
(Please refer to
IVR Function Table
for function codes).
Example:
If your password is “1234”, enter
**1234#
so that you are now in IVR setup mode.
Next enter a function code to check or configure the gateway. If your password is “admin”,
enter
***4144534954#
.
FXO Port: Use extension line to dial the phone number of FXO port. You will hear the
instruction “enter value”, enter factory default code ** # to access IVR mode. If it requires
password, enter ** password #. Character to number conversion information is provide in the
PPPoE Character Conversion Table
. After entering the correct IVR password, you will
hear an indication tone after which the gateway is in IVR setup mode. Enter function codes
to check or set the gateway configuration.
Once the first setting or query has been completed, you will hear a dial tone. Use the same
procedure to make a second query or setting. To exit IVR mode, simply hang up the phone.
Example:
enter
**#
(You are now in IVR mode)
enter
101
(to query about the current IP
address)
the gateway responds with an IP address
you can continue with more
settings or queries: enter
111
(to set a new IP address)
enter
192*168*1*2
(new IP
address).
Save Settings
After completing all of your settings, dial 509 (Save Settings). Wait for about 3 seconds, you should
hear a confirmation tone “1.” You can now hang up the phone. Please reboot the gateway to
enable new settings.
To inquire about the current gateway’s WAN Port IP address
After completing all of your settings, dial
101
. The gateway will repeat the current WAN Port IP
address. If the gateway does not repeat the IP address, this indicates that the gateway is not
currently connected to the Internet. Please check to be certain that the cable connection, account
number, and password are all correct.
Software Upgrade
IVR provides online upgrades. Once in IVR mode, enter “
209
” and you will hear “Enter Value“.
Enter your IP address followed by “#” (i.e.:
61*30*25*89#
). You will hear a second “Enter Value“.
Enter the Listen Port Number followed by “#” (i.e.:
69#
).
NOTE: Please contact your service provider for software upgrade.
