48
2000I & 2000M User Guide, Rev B
connector is located in the upper, center and is a 0.101 sub-miniature phono
socket. The recommended mating plug is obtainable from Switchcraft® as
part number 850. The connector is provided with each instrument as standard
and when MEM is ordered. (Xitron Technologies part number
C109001001000001).
General Memory Considerations
Memory of Instument Status
The contents of a memory step only affect the selection of the “Operate” or
“Standby” status when the memory step is initially recalled. To change the
state following recall use the method outlined in
Front Panel Operation
.
Editing Memory Steps
The contents of a memory step may be edited at any time, if the memory step
being edited is presently in use, then note that the present output level will be
updated when the memory step is next recalled.
Adjusting the Output Level
The “Adjust” mode
of operation of the instrument may be used in
conjunction with recalling memory steps. Recalling a memory step while in
this mode
sets the actual output level and the nominal output level to that
recalled from the memory. In this manner you are not required to deselect
“Adjust” mode when sequentially
recalling steps from memory.
Thermocouple Simulation
Only the simulation temperature and the temperature units are stored in a
memory location. This feature allows you to change thermocouple type or
change between
Active
and
Passive Cold Junction Compensation
without
reprogramming the memory steps.
Summary of Contents for 2000I
