Concentricity
◆
When installing the servo motor, make it meet the centering
precision requirements as shown below. If the centering is not sufficient,
vibration may occur, and sometimes the bearing and encoder may be
damaged. When installing the shaft coupler, please do not directly
impact the motor shaft, otherwise it will damage the encoder installed
on the load reverse side of shaft end.
Installation
direction
◆
The servo motor can be mounted horizontally or vertically
Oil and water
solution
When using in places with drops of water, please use it on the basis of
confirming the protection level of the servo motor. Specify a servo
motor with an oil seal when there is an oil droplet that drips to the
through part of the shaft.
Using condition of motor with oil seal:
When using, please make sure the oil level is lower than the lip of the
oil seal.
Please use the motor in a condition where the oil seal keeps the spray
Measure it at 4 places of the circle, the
difference should be below 0.03mm.
Measure it at 4 places of the circle, the difference should be
below 0.03mm.
