Xilinx Zynq UltraScale+ ZCU104, User Manual

Page: 17 / 92

ZCU104 Board User Guide 17
UG1267 (v1.1) October 9, 2018 www.xilinx.com
Chapter 2: Board Setup and Configuration
Quad SPI
To boot from the dual Quad SPI nonvolatile configuration memory:
1. Store a valid Zynq Ult MPSoC boot image in the Quad SPI flash device (U119)
connected to the MIO Quad SPI interface.
2. Set the boot mode pins SW6 [4:1] PS_MODE[3:0] as indicated in Table 2-4 for Quad
SPI32.
3. Either power-cycle or press the power-on reset (POR) pushbutton SW4. SW4 is callout 20
in Figure 2-1 .
SD
To boot from an SD card:
1. Store a valid Zynq Ult MPSoC boot image file on to an SD card (plugged into SD
socket J100) connected to the MIO SD interface.
2. Set the boot mode pins SW6 [4:1] PS_MODE[3:0] as indicated in Table 2-4 for SD1.
3. Either power-cycle or press the power-on reset (POR) pushbutton SW4. SW4 is callout 20
in Figure 2-1 .
See the Zynq Ult MPSoC Technical Reference Manual (UG1085) [Ref 2] for more
information about Zynq Ult MPSoC configuration options.
Send Feedback