Xerox WorkCentre M24 Color, User Manual

Page: 378 / 441

4–44
U
S E R
G
U I D E
(M
A C H I N E
A
D M I N I S T R A T O R
)
Allocate Memory
Allocate Memory determines memory volume for the reception
buffer, where the data transmitted from clients is stored, for each
interface.
For LPD, SMB and IPP you can set whether or not to spool to
memory, and where to spool. The assigned memory size when
spooling to memory can also be configured (LPD and SMB only).
The size of the reception buffer can be changed according to
machine's conditions and your requirements. If the reception
buffer is increased, clients using each interface may be released
quicker. The maximum value you can set changes according to
the amount of available memory.
NOTE: When the memory size is changed, the memory will be
reset, and the data stored in each memory area will be erased.
NOTE: If the set values exceed the size of the installed memory,
the system automatically adjusts the memory allocation when the
power is turned on.
NOTE: When a port is set to Disabled, corresponding items will
not be displayed.
The following items can be configured in Memory Settings.
PCLe Memory Set the memory size for PCLe.
The memory size can be set between 2.50 ~ 32.00 MB, in
increments of 0.25 MB.
PostScript Memory Set the amount of memory used by PostScript. This item will be
displayed only when a PostScript software kit is installed.
The memory size can be set between 8.00 ~ 32.00 MB, in
increments of 0.25 MB. The maximum value depends on the
amount of available memory. The default is 16.00 MB.
HP-GL/2 Auto Layout
Memory
Set the memory size for HP-GL/2.
This item only appears when the machine is equipped with PS-
ROM. The size can be set between 64 KB ~ 5120 KB, in
increments of 32 KB. The maximum value depends on the amount
of available memory. The default is 64 KB.
Receiving Buffer-Parallel Set the receive buffer on the parallel interface.
The memory size can be set between 64 ~ 1024 KB, in increments
of 32 KB. The default is 64 KB.