Xerox WorkCentre 5945, Quick Start Manual

Page: 7 / 69

Safety and Regulations WorkCentre
®
XXXX
4 User Guide
Electrical Supply
This document provides important electrical supply safety information that you should read before
installing or using the device.
Read the information in the following sections:
• Power Outlet Electrical Safety
• Power Cord Electrical Safety
• Device Safety
• Emergency Power Off
• Disconnect Device
Power Outlet Electrical Safety
This device must be operated from the type of electrical supply indicated on the data plate label
located on the rear cover of the device. If you are not sure that your electrical supply meets the
requirements, please consult your local power company or a licensed electrician for advice.
The electrical supply outlet should be installed near the device and should be easily accessible.
WARNING
This device must be connected to a protective earth circuit. This device is supplied with a
plug that has a protective earth pin. This plug will only fit into an earthed electrical outlet. This is a
safety feature. If you are unable to insert the plug into the outlet, contact a licensed electrician to
replace the outlet. Always connect the device to a correctly grounded power outlet. If in doubt, have
the outlet checked by a qualified electrician. Improper connection of the device-grounding conduc-
tor can result in electrical shock.
Power Cord Electrical Safety
• Use only the power cord supplied with this device.
• Plug the power cord directly into a grounded electrical outlet. Do not use an extension cord. If
you do not know whether or not an outlet is grounded, consult a qualified electrician.
• Do not place this device where people might step on or trip on the power cord.
• Do not place objects on the power cord.
• To reduce the risk of fire, use only No. 26 American Wire Gauge (AWG) or larger
telecommunication line cord.
Device Safety
This device has been designed to provide operator access to safe areas only. Operator access to
hazardous areas is restricted using covers or guards, which require a tool to enable removal. Never
remove the covers or guards that protect hazardous areas.