Xerox WorkCentre 5022, User Manual

Page: 228 / 360

Tools
Xerox
®
WorkCentre
®
5022/5024 Multifunction Printer
User Guide
9-42
System Settings
Used to make other settings.
For information on how to display the
System Settings
screen, refer to System Settings Procedure on
page 9-1.
Power Saver Timer
Used to make settings for the Energy Saver function.
Low Power Mode
Sets the amount of time the machine waits before entering Low Power mode.
You can set a value between 1 and 60 minutes (in 1 minute increments).
The machine's power is not turned OFF completely in Low Power mode. Instead, this mode creates a
balance between low power consumption and short warm-up time by controlling the temperature of
the fusing unit to a level midway between the power OFF temperature and the "Ready" temperature.
1 minute
is set at the time of factory shipment.
Sleep Mode
Used to set the amount of time the machine waits before entering Low Power mode or Sleep mode.
You can set a value between 1 and 239 minutes (in 1 minute increments).
Sleep mode minimizes power consumption by shutting off the power to all components except the
controller. Warm-up time in Sleep mode is longer than in Low Power mode.
1 minute
is set at the time of factory shipment.
Auto Reset
Sets the amount of time the machine waits before automatically returning to the Default Display
screen when no operation is being performed.
You can select
15 seconds
,
30 seconds
,
45 seconds
,
1 minute
,
2 minutes
,
3 minutes
, or
4 minutes
.
45 seconds is set at the time of factory shipment.
Auto Print
Used to set the amount of time the machine waits after operating the control panel, loading paper on
the document feeder, or closing a tray until starting to print automatically.