Xerox WorkCentre 5019, User Manual

Page: 175 / 184

Appendix
WorkCentre 5019/5021
User Guide 12-7
Notes and restrictions
This section describes the notes and restrictions to observe when using the machine.
Notes and restrictions on the use of the machine
Notes on switching off the power
After the power is switched off, the machine performs internal power off processes for a while. After
turning the power off, turning it on again before the screen display has disappeared will not start the
machine right away. Before turning the power on, check that the operation screen display has
disappeared.
Installing and moving the machine
• Contact our Customer Support Center or a Customer Engineer before moving the machine.
• Do not subject the machine to shocks while it is in operation.
• Take care not to get fingers caught when closing the document cover.
• Do not place objects near fan intakes on the machine's outer casing.
Character codes
In data transmission from a computer, if characters that the machine does not support are included in
the file names, these characters may not be displayed correctly. Only ASCII characters can be used.
Hard disk
You cannot install a hard disk into this product.
Printing results
• Depending on the type of media used, rubber roller marks may be left behind along the scanning
direction or toner wax components adhere to the paper during 2 Sided printing or when the
output destination is changed during continuous printing.
• Droplets of water may adhere to the printing paper immediately after the power is turned on to
the machine.
• Depending on the type of media used, pinch roller marks and minute scratches may form in the
scanning direction.
• During two-side printing with coated paper, indentations may appear on the back side of the
paper.
• Line unevenness may occur along the scanning direction in high-volume printing in low-humidity
environments.
• Colors may appear muted on the underside of high-density images in printing in low-temperature,
low-humidity environments.
• Small white spots may appear within images on the back side of the paper in printing in low-
humidity environments.