English
Xerox WorkCentre 3550
Quick Use Guide
14
Network Setup
IP Address Assignment
After the machine starts, it negotiates with the DHCP server for an IP Address.
Wait two minutes for the network setup to complete and then print the
configuration page to check if an IP Address has been assigned. To print a
configuration page:
1.
Press
Machine Status
on the control panel.
2.
Press the up/down arrows to highlight
Information Pages
and press
OK
.
3.
Press the up/down arrows to highlight
Configuration Page
and press
OK
.
4.
Highlight
Yes
and press
OK
to print the configuration page.
5.
Confirm that an IP Address has been
allocated and that it is an appropriate IP
Address for your network.
Note:
If the IP Address starts with
169.xxx.xxx.xxx, the DHCP server has not
properly allocated an address or DHCP is
not enabled on your network. Refer to
Network Setup Using DHCP
on
page 14 or the
Network Setup Using a Static IP Address
on page 15 for
instructions. If you need assistance, contact your System Administrator.
Network Setup Using DHCP
1.
Press
Machine Status
on the control panel.
2.
Press the up/down arrows to highlight
Network Settings
and press
OK
.
3.
Enter the Administrator’s Password using the keypad. The default is
1111
.
Note:
You may have to press the
1
key several times to enter the ‘1’.
After entering a character press the
Right
arrow button to enable the
next character to be entered, or wait 2 seconds between presses.
Continue entering characters until the full password has been entered
and press
OK
.
4.
Press the up/down arrows to highlight
TCP/IPv4
and press
OK
.
5.
Press the up/down arrows to highlight
DHCP
and press
OK
.
6.
Print a configuration page to confirm that an IP Address has been
allocated and that it is an appropriate IP Address for your network. Refer
to
IP Address Assignment
on page 14 for instructions.
7.
Press
Stop
to return to ready mode.
