4. Remove the fuser cover by using the T10 Torx driver to unscrew the one mounting
screw at the center of the cover.
5. Locate the fuser identifier clip on the fuser assembly and, using a marker, write on
the identifier the fuser width being used.
6. Locate the two bypass fuser connectors in the kit. The black resistor jumper (left) is
used for the 2 range value and the blue jumper (right) represents the 3 range value.
For the Range Numbers, refer to the Bypass Connector table in
.
5-33
Xerox
®
Versant™ 2100 Press
Quick Start Guide
Maintenance
