Xerox Travel Scanner 150, User Manual

Page: 160 / 194

Xerox Travel Scanner 150
User’s Guide 160
There are some features in the scanner interface that are disabled until a module is installed that contains those
options. When the module is installed, the features will enable in the scanner interface for you to use them.
Reordering the Modules
Select a module in the list and click the up or down arrow to change the order of the module in the list. Changing the
order of the modules changes the order in which the image processing options are used. For example, if there are
two modules installed and both modules include an automatic image rotation option, the first module's rotate
option is used and the rotate setting in the second module is ignored so that the image is not rotated twice.
Hardware Settings
The scanner configuration tab shows the hardware information for your scanner.
Paper Pickup Options
The Paper pickup options allow you to choose how the scanner responds when a page is inserted into the scanner.
•
Delay —this is the amount of time between when the paper sensor is engaged and the rollers start to feed the
page into the scanner. When the TWAIN interface is open, or when automatic scanning is disabled, the page is
pre-fed and then the scanner waits until you click Scan in the interface before it will continue to feed and scan
the page. When automatic scanning is enabled and the TWAIN interface is closed, the scanner will
automatically feed and scan the page using the settings in OneTouch.
Increasing the delay time allows you to make sure the page is in straight before the scanner starts to feed it
through. If the delay time is 0 ms (milliseconds), the scanner starts as soon as the paper sensor detects that a
page has been inserted. You can set the delay time between 0 milliseconds (no delay) and 1250 milliseconds
(1.25 seconds).
Note that automatic scanning is only available when OneTouch is installed. Please refer to the
Application
Settings section for instructions to enable or disable automatic scanning.
• Insertion depth —this is how far into the scanner the page is pre-fed after the paper sensor has been
engaged.
Skew Detection
By default, the scanner is set to detect when the item being scanned is at an angle, also called skewed. It will stop
scanning and back the item out of the scanner. Click on
Enable the detection of excessive document skew. Back
out the document if this occurs.