Xerox Legacy 4590, System Administration Manual

Page: 117 / 402

Xerox 4590/4110 Copier/Printer System Administration Guide
5-25
5. Using the Scan Service
3.
Enable the SNMP port.
a. Select
Network Settings
.
b. Select
Port Settings
.
c. Select
SNMP
and then select
Change Settings
.
d. Select
SNMP - Port
and select
Change Settings
.
e. Select
Enable
and then select
Save
.
f. Select
Close
.
4.
Enable the Internet service (HTTP) port as above.
5.
Select
Close
.
6.
Set the IP address.
If the IP address is already set, this step is not necessary.
Also, in an environment with DHCP or BOOTP, configure the
way to obtain the address. If the address cannot be obtained
automatically or manual configuration is preferred, configure
the IP address, subnet mask, and gateway address.
a. Select
Protocol Settings
.
b. Select
TCP/IP - Get IP Address
and then select
Change
Settings
.
c. Select one from
DHCP
,
BOOTP
,
RARP
,
DHCP/Autonet
or
Manual
. If you select anything other than
Manual
,
proceed to step 7.
NOTE: When using a DHCP server, also configure the
WINS (Windows Internet Name Service) server.
d. When
Manual
is selected, select
TCP/IP - IP Address
then
Change Settings
.
e. Select
TCP/IP - Get IP Address
and then select
Change
Settings
.
f. Enter the IP address using the numeric keypad.
NOTE 1: Enter address in the format “xxx.xxx.xxx.xxx”
where xxx should be a numeric value in the range from 0
to 255. However, 224 or 225.xxx.xxx.xxx and
127.xxx.xxx.xxx cannot be used.
NOTE 2: When you make an entry mistake, press the C
(Clear) button and enter again.
NOTE 3: When you would like to move to the next value
without entering all 3 digits, select Save/Select Next.