3/99
Xerox DocuPrint P1202 Service Manual
7-5
Repair Analysis Procedures (RAP)
22 Request the customer to set the RCP Page Tab to 2nd Cassette. Press and hold the Front Panel
Key until all four LEDs flash. Release the Front Panel Key. Paper is fed from the lower Paper
Tray.
Y
N
|
Go to RAP 7.11.
23 The printer appears to be functioning properly. If the customer reported a Status Monitor Fault /
Message that has not been corrected, see Table 7.2. Status Monitor Fault / Message Table.
Table 7.2. Status Monitor Fault / Message Table.
Status Monitor Message
Corrective Action
On Line
Normal Operation, no action required.
Off line
Press the Front Panel Key to go Online. The Ready LED is illuminated.
Warming Up
Normal Operation, fuser is warming to operating temperature.
Paper Tray Open or Empty
Place paper in the paper tray. Ensure that the paper tray is fully inserted into the
printer. Verify that the paper empty actuator moves freely. Replace the Engine
PWB (PL 5).
Cover Open or Missing
Printer Cartridge
Verify that the Printer Cartridge is properly installed. Verify that the Front Cover is
properly closed. Verify that the printer cartridge/front cover interlock actuator
moves freely. Replace the Engine PWB (PL 5).
Paper Jam 0
Go to RAP 7.6.
Paper Jam 1
Go to RAP 7.6.
Paper Jam 2
Go to RAP 7.6.
Scanner Error (LASER)
Replace the LASER Assembly (PL 4).
Fuser Error
Replace the Fuser Heat Rod (PL 5). Replace the Fuser Assembly (PL 5). Replace
Print Engine PWB (PL 7).
Input/Output (I/O) Error
Inspect printer cable for damage and for proper connection, replace if necessary.
Cable supports bi-directional operation. Verify settings of host computer match
printer settings. Replace the System Controller PWB (PL 7).
Memory Full
Print job too large for printer memory. Add additional memory to printer or reduce
the page complexity.
Band Error
Print job too large for printer memory. Add additional memory to printer or reduce
the page complexity.
Port Not Available
Communications problem, go to RAP 7.9.
Unknown Status
Using the DCU, verify the Laser and Fuser operation, replace if necessary (PL 4 )
or (PL 5).
www.printcopy.info
www.printcopy.info
