3/99
General Procedures and Information
5-30
Xerox DocuPrint P1202 Service Manual
NOTE: Ensure that you install the Memory SIMM into slot 2 of the Controller PWB.
NOTE: The SIMM slots are not interchangeable, you may damage the PWB if you attempt to install
either SIMM in the wrong slot.
5 Orient the new memory module so that the side with the contacts is closest to the printer, and the
notched end of the module is on the top (Figure 5.6.0c).
Figure 5.6.0a
6 Hold the SIMM at a vertical 30 degree angle and firmly push it with your thumbs into the slot.
Push the module into the back of the slot to fully seat it (Figure 5.6.0d)).
Figure 5.6.0a
7 Rotate the module to the right until the clips on the edges of the slot snap/click onto the module.
8 Reinstall the Shield and the right side cover panel.
9 Run a Status Page to verify memory has been installed correctly and system recognizes the
installation of additional memory
egl_414c
Slot 1
Slot 2
egl_415c
Slot 1
Slot 2
www.printcopy.info
www.printcopy.info
