Setting up APPSOCKET
2-18
❖
DocuPrint Technical Information Guide
Setting from
Windows or Unix
Operating Systems
Perform these steps to enable or disable AppSocket using
telnet from a Windows or Unix OS. Some DocuPrint
network printers do not support telnet. For these printers,
change the AppSocket setting from the Control Panel as
described in the previous section.
1
Open a telnet session.
Windows: Open a MS-DOS window, type
telnet
x.x.x.x[Enter]
, where
x.x.x.x
is the IP address
Unix: Type
telnet hostname
in a shell
2
Type
![Enter]
and then
yes[Enter]
to enter monitor mode.
3
Select the Network Protocols Menu,
N[Enter]
.
4
Select the TCP/IP Options Menu,
T[Enter]
.
5
Select the Socket Options Menu,
S[Enter]
.
6
Type
y[Enter]
.
7
Select
y [Enter]
to enable or
n [Enter]
to disable
AppSocket (TCP Sockets)
8
Type
[Enter]
.
9
Select
X [Enter]
to exit this menu or end the telnet
session.
Telnet only works if the device is on the same subnet as the
host (i.e. computer or workstation).
Summary of Contents for DocuPrint N2825
