Setting a SUBNET MASK at the Control Panel
2-16
❖
DocuPrint Technical Information Guide
6
When you have completed setting the IP address, press
Enter
. You will see:
E t h e r n e t M e n u
S u b n e t M a s k
7
Press
On Line
. You will see:
Ready
Setting from
Windows or Unix
Operating Systems
Perform these steps to enter the Subnet Mask using telnet
from a Windows or Unix OS. Some DocuPrint network
printers do not support telnet. For these printers, enter
the Subnet Mask from the Control Panel as described in
the previous section.
1
Open a telnet session.
Windows: Open a MS-DOS window type
telnet
x.x.x.x[Enter]
, where
x.x.x.x
is the IP address
Unix: Type
telnet hostname
in a shell
2
Type
![Enter]
and then
yes[Enter]
to enter monitor mode.
3
Select the Network Protocols Menu,
N[Enter]
.
4
Select the TCP/IP Options Menu,
T[Enter]
.
5
Select the Engine Options Menu,
E[Enter]
.
6
Type
y[Enter].
7
Select Subnet mask,
m[Enter]
.
8
Enter the new Subnet Mask,
[Enter].
9
Select
X [Enter]
to exit this menu or end the telnet
session.
Telnet only works if the device is on the same subnet as the
host (i.e. computer or workstation).
Summary of Contents for DocuPrint N2825
