Xerox DocuPrint 92C NPS, Maintenance Guidance

Page: 26 / 62

FUSER LUBRICANT AND PRESSURE ROLL WIPER
4-4 XEROX DOCUPRINT 92C NPS GUIDE TO PERFORMING ROUTINE MAINTENANCE
12. Close the printer doors.
13. Wash your hands to remove any fuser lubricant.
Replacing the pressure roll wiper
You need to replace the pressure roll wiper when any of the following
occur:
•
Excessive oil or dirt buildup appears on the wiper.
•
The first few prints of a job have oil or dirt on them.
•
An interval of 80,000 to 100,000 prints are made. (The number
of prints made is tracked by the billing meter, which you can
view with the Display Billing Meters command.)
Your service representative usually replaces the pressure roll wiper
for the DocuPrint System. However, you might choose to replace the
pressure roll wiper yourself if you have been trained in this
procedure.
To replace the wiper:
1. Power off the printer.
2. Open the printer doors and locate the fuser drawer.
3. Move the green lever (A) counter-clockwise, grasp the green
handle on the fuser drawer, (B) and pull it out until it stops.
B
A
B
A