FUSER LUBRICANT AND PRESSURE ROLL WIPER
XEROX DOCUPRINT 92C NPS GUIDE TO PERFORMING ROUTINE MAINTENANCE
4-3
7. Open a tube of fuser lubricant and cut the pointed spout
diagonally. Carefully squeeze the lubricant into the reservoir
until the orange float reaches the top (C), or until you see the oil
reach the top edge below the fuser cap. The reservoir may
require up to two tubes of lubricant if it was empty.
8. Replace the reservoir cap by turning it clockwise.
9. Close the fuser drawer by pressing down on the green latch (A)
and pushing the fuser drawer in until it latches in place.
10. Dispose of the drop cloth and any empty lubricant tubes in a
trash receptacle. If there is any lubricant left in the tube, cap the
tube and store it for future use.
11. Remove and dispose of the gloves in a trash receptacle, being
careful not to let any residue come in contact with your skin.
C
A
Summary of Contents for DocuPrint 92C NPS
