XEROX DOCUPRINT 92C NPS GUIDE TO PERFORMING ROUTINE MAINTENANCE
4-1
4.
4
Fuser lubricant and pressure
roll wiper
This chapter describes how to add fuser lubricant and how to replace
the pressure roll wiper on your system.
Adding fuser lubricant
The fuser uses heat to fuse the print image to the paper. It is critical
that the fuser be kept lubricated with fuser lubricant and that its
reservoir be kept full. This chapter describes the procedure for
adding fuser lubricant to the printer.
You need to add fuser lubricant when the Attention light turns a
steady yellow and the following message displays on the printer
control console:
LOW ON FUSER LUBRICANT
Once the lubricant runs out, the printer stops.
FUSER LUBRICANT CONTAINER IS EMPTY
Your service representative usually adds fuser lubricant. However,
you might choose to add the fuser lubricant yourself if you have been
trained in this procedure.
To add fuser lubricant:
1. Open the printer doors.
2. Place a dropcloth on the floor under the fuser area.
!
Warning:
If any fuser lubricant is spilled, remove it
immediately. Fuser lubricant spills cause the floor to be very
slippery.
3. Press down on the green lever (A), moving it counterclockwise.
Summary of Contents for DocuPrint 92C NPS
