Xerox Document centre 250 series, User Manual

Page: 72 / 185

60
4
4.3 Configuring the Printer Drivers
First Sheet
Enables you to select for the first sheet of your document, a paper source different from
the rest of the output sheets as selected in Paper Source on the "Paper/Output" tab. Note
that the paper size used for this different paper source must be the same as the document.
Different Paper Source
This check box must be selected before the drop-down list of paper source options is
enabled. Disabled in any one of the following conditions:
(a) Postcard or Custom Paper Size is selected for Paper Size on the "Paper/Output"
tab;
(b) N-Ups is selected for Layout Mode on the "Layout" tab and more than 1-Up is
selected for Pages Per Sheet (for PCL 6 drivers only); or
(c) Booklet Printing is selected for Layout Mode on the "Layout" tab (for PCL 6
drivers only).
Default is off.
The options available for the different paper source are identical to the settings of Paper
Source on the "Paper/Output" tab. Default is Auto Tray.
CentreWare Supports (for all except Windows 3.1 drivers)
The Document Monitor tool must be installed on the computer in order for the following
check boxes to be enabled:
Use Document Monitor
The Document Monitor is a CentreWare software tool that enables network users to
monitor and track the status of documents (print/fax jobs) being processed by the
Xerox Document Centre System. Enabled if CentreWare is installed. Default is off.
Enable Raster/EMF Spooled Jobs (for Windows NT 4.0 drivers only)
A raster print job or an EMF spooled job on Windows NT 4.0 system may not be
successfully monitored by the Document Monitor. This option allows users to
specify Raster and/or EMF settings. Enabled if Use Document Monitor is selected.
Default is off.
Metafile (EMF) Spooling (for Windows NT 4.0 drivers only)
Specifies the format in which to store printing information on your disk while a job is
waiting to be printed. Turning this control on will enable the EMF disk file format.
Otherwise, RAW format will be used. Enabled in either one of the following conditions:
(a) Vector is selected for Graphics Mode on the "Graphics" tab; or
(b) Enable Raster/EMF Spooled Jobs is selected for CentreWare Supports.