PRINTER MAINTENANCE
If the files you are copying exceed the storage capacity
of the diskette, the system displays the following
messages:
** DISKETTE IS FULL **
REMOVE CURRENT DISKETTE
AND INSERT ANOTHER DISKETTE
ENTER: C
CONTINUE
COPYING
X
TO ABORT CURRENT SAVE
Unload the diskette in the drive and load a formatted
disk, then enter C to continue the copying process.
f.
To copy files from a diskette to the system disk, enter
the following command:
FLOPPY RESTORE [REVIEW] [disk-id [input-file-id
[output-file-id] ALL|file-type]
REVIEW
Displays a warning message when the file to be
copied is about to overwrite a file of the same name
already on the system disk, and asks if you want to
continue. Enter Y to overwrite the file, N to skip
the file, or X to abort the copy process.
[disk-id]
Identifies the system disk to copy the file to (DP1:,
DP2:, or DP3:). You do not need to enter this
parameter.
file-id
Specifies the full name of the file to copy (including
its extension).
[output-file-id]
Specifies the name of the file to be written if it is
different than the name of the source file. If
output-file-id is not specified, the name of the
source file is used.
ALL|file-type
Specifies the files to copy.
ALL
Copies all files on the tape to the system disk.
file-type
Copies all files with a specified extension (file
type) to the system disk.
Handling diskettes
Observe the following guidelines when handling diskettes:
•
Hold the diskette by its cover. Do not touch the portions
that show through the cutout areas in the disk cover.
•
Store the diskette in its protective sleeve when it is not in
use.
•
Write on diskette labels before you apply them to the
diskette. Do not write on diskettes or on labels that are
attached to the diskette.
•
Do not attempt to clean a diskette.
XEROX 4050/4090/4450/4650 LPS OPERATOR GUIDE
6-15
